Aigean Dual Band WiFi Extender AN-7000
WiFi Extender

Aigean Dual Band WiFi Extender AN-7000

  • Vendor:Aigean
  • Category: Latest Products
Availability: In Stock
$2,745.00
or
Wishlist Compare

Aigean Dual Band WiFi Extender AN-7000

The AN-7000 is Aigean’s newest and most capable Wi-Fi client featuring high powered dual-band connectivity. From the attractive, powder coated case to the elegant and intuitive firmware, the AN-7000 is perfect for vessels of all types and sizes.

Top-tier performance and years of service are guaranteed with the use of the highest quality components and inclusion of industry trusted Comrod antennas. The AN-7000 includes a robust power regulation system that allows efficient operation from 12 to 35 V DC. Additionally, a unique mounting system makes it easy to attach to any surface. WiFi networks 802.11a/b/g/n compatible.

Features

Dual Band Technology
2.4 GHz and 5 GHz support. Significantly increase connection opportunities
and speed by utilizing 5 GHz networks when available.

High Throughput
A super-fast chipset coupled with lightning fast 5 GHz 2x2 MIMO radio allows
for maximum potential speeds in excess of 980 Mbps.*

Gigabit Ethernet
Transfer data 10x faster than Fast Ethernet, ensuring high-speed and lower
latency connectivity for wired devices on the vessel.

System Information

Processor Atheros MIPS 74Kc, 750MHz
Memory 128MB SDRAM, 128MB NAND Flash
Networking Interface 1 x 10/100/1000 BASE-TX (Cat 5, RJ-45) Gigabit Ethernet

2.4 GHz Radio

Protocol(s) 802.11b/g/n Wi-Fi with MIMO (2x2)
Tx Power ≤30 dBm (1W)
Rx Sensitivity minimum -96 dBm

5 GHz Radio

Protocol(s) 802.11a/n Wi-Fi with MIMO (2x2)
Tx Power ≤30 dBm (1W)
Rx Sensitivity minimum -96 dBm

Physical / Electrical / Environmental

RF Connector 4x N-type Male Jack (two for each radio/band)
Enclosure Size 11.9" x 9.3" x 1.5" (300mm x 266mm x 36.7mm)
Weight 5 lbs (2.27 kg)
Enclosure Characteristics Powder coated die cast aluminum enclosure with rubber seal, ABS plastic mounting plate, and stainless steel hardware
Power Rating 8-35 V DC - input internally regulated
Operating Temperature -40°F to 158°F (-40°C to +70°C)
Operating Humidity 5 to 95% Condensing
Shock and Vibration ETSI300-019-1.4
Environmental Resistance IP65 (NEMA 4)
  • AN-7000 device
  • 2x Comrod marine antenna (4 ft / 121 cm)
  • 2x Secondary rubber antenna (5 in / 12 cm)
  • 2x LMR-400 low loss cable (25 ft / 762 cm)
  • 2x LMR-400 N-Male connector w/ heat shrink
  • Power cable (6 ft / 182 cm)
  • Quick Start Guide
  • Warranty Information

Installation Notice: This device is intended to be professionally installed. Installation requires proper antenna placement and mounting, cable run(s) and termination, and 12V DC power connection. Failure to meet installation guidelines and requirements may void device warranty.

Performance Notice
Actual performance may vary. The standard transmission rates described are the physical data rates and actual data throughput will be lower. Factors affecting signal strength and quality include localized radio frequency interference, obstacles impeding clear line-of-sight, antenna positioning, access point hardware/configuration, and atmospheric conditions, among many others.